Most of us who use computers either in our personal or professional lives will be familiar with the idea of computer storage and some of the units which are used to design storage capacity at the lower end of the spectrum. The following article provides an overview of all of the units that have, as of present, been classified as SI units (International System of Units) including the familiar kilo-, mega- and gigabytes.
Before looking at its multiples it is worth becoming familiar with the concept of a byte (B) and what it represents. The fundamental unit of computer information storage is actually a bit (short for a binary digit) which is a binary concept in that it exists in one of two states, 1 or 0. A byte in turn is derived from eight bits because that was generally the number needed to form the smallest unit of meaningful data – a single character of text. Therefore, a byte is usually now equivalent to an 'octet' of bits although it can and has varied depending on the hardware in question. The word itself actually originated in 1956 as an intentionally incorrect spelling of the word bite to avoid corruption back to its smaller constituent, the bit.
Bytes can be measured in decimal (multiples of ten) or binary (multiples of two), again depending on the manufacturer of the hardware in question and unofficial convention. The following are decimal multiples as specified by the SI classification but the binary use of the terms is actually far more prevalent in practice. For every 1,000 bytes, the nearest binary equivalent would be 1,024 bytes. As binary systems us the concept of two states (eg, true / false, off / on, 1/0, positive / negative) to represent information the binary multiples use doubling rather than factors of ten. To achieve the nearest equivalent value to 1,000 before the sequence 2, 4, 8, 16, 32, 64, 128, 256, 512, 1,024 is used; 1,024 being two to the power of ten (ie, 210). At the lower end of the scale, binary and decimal equivalents are fairly close to each other (1,000 vs 1,024 is different by 2.4%), but as the scales grow the difference is magnified to the greater that the nearest equivalent multiples are almost 21% apart when considering 280 and 1024.
To avoid confusion between decimal and binary values, binary specific units have been standardized by the International Electrotechnical Commission (IEC) although the SI terms are still most frequently used to refer to the binary values.
Kilobyte
Megabyte
Gigabyte
Terabyte
Petabyte
Exabyte
Zettabyte
Yottabyte
Table of Contents Introduction to IT Managed Service Providers Why Outsource IT Management? Cost-Effective Solutions…
Key Takeaways: The importance of selecting the correct thresholds for different areas in your home…
Key Takeaways: The variety of railing gate designs can significantly enhance the aesthetic appeal of…
For many, commuting is an unavoidable part of daily life. But when that commute extends…
When you're on the road, you want to feel safe, comfortable, and like you have…
Key Takeaways: Understanding the significance of indoor air quality. Identifying common pollutants in your home.…